CLOSE requested (1)
CLOSE requested (1)
dynamic CA: 23 01 02 20 04 c0 a8 fe 18 21 04 ff ff ff 00 22 04 c0 a8 fe 02 27 01
 0a 24 01 00 28 01 14 01 01 00 46 01 00 47 01 00 31 01 01 33 01 fe 32 01 00 19 0
1 00 18 01 01 11 01 01 10 00 13 01 00 12 00 15 01 00 14 00 17 01 05 16 13 2f 61
75 74 6f 65 78 65 63 5f 64 6d 38 30 30 2e 62 61 74 1b 01 01 1a 3c 63 6f 6e 73 6f
 6c 65 3d 74 74 79 53 30 2c 31 31 35 32 30 30 20 72 6f 6f 74 3d 2f 64 65 76 2f 6
d 74 64 62 6c 6f 63 6b 33 20 72 6f 6f 74 66 73 74 79 70 65 3d 6a 66 66 73 32 20
72 77 45 01 00 ff 02 00
(c) 2007,2008 Dream Multimedia GmbH. All rights reserved.
Dreambox DM800
FIRST STAGE 1.00 {BO23456}

2ND STAGE OK, build #75 (20091005)

0.000  - BCM board setup
{00000126,00000126,00000125,00000124,00000123,00000133}
0.007  - fp init
0.008  - ca init
0.732  - load config
0.760  - config loaded.
 * press [S] to enter setup
OLED found!
 BOOT #75(20091005)
UNKNOWN FLASH [ff ff ff ff]! assuming 64MB!
detected jffs2 blocksize: 16kb
+B+++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++
+++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++
+++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++
+++++++++++++++++++++++++++++++++++++++++++++++++++
dreamupd initialized
Scanning JFFS2 FS: . done.
/flash/bootlogo.elf
bootlogo size: 53210
using 1280x720p (60.00 Hz)
Using the Small jpeg decoder library, Copyright (c) 2006, Luc Saillard <luc@sail
lard.org>
parsing JPEG header..
JPEG Size: 1280x720
/flash/vmlinux.gz
<5>Linux version 2.6.18-7.1-dm800 (newnigma2@vs35) (gcc version 4.4.3 (GCC) ) #1
 Mon Mar 1 17:16:10 UTC 2010
Fetching vars from bootloader... none present, using defaults.
board_init_once: regval=44ac6502, ddr_strap=3, 4 chips, pci_size=2
Detected 256 MB on board
<4>WARNING: read invalid MAC address ff:ff:ff:ff:ff:ff from flash @ 0xbffff824
Default command line =
root=/dev/mtdblock3 rootfstype=jffs2 rw console=ttyS0,115200
2 831ffed8 8303c398
g_board_RAM_size=256MB
Options: sata=1 enet=1 emac_1=0 no_mdio=0 docsis=0 ebi_war=0 pci=1 smp=0
CPU revision is: 00020000
Determined physical RAM map:
 memory: 10000000 @ 00000000 (usable)
---> memsize from bootloader: 148
User-defined physical RAM map:
node [00000000, 09400000: RAM]
node [09400000, 06c00000: RSVD]
<5>Reserving 108 MB upper memory starting at 09400000
<7>On node 0 totalpages: 65536
<7>  DMA zone: 65536 pages, LIFO batch:15
Built 1 zonelists.  Total pages: 65536
<5>Kernel command line: console=ttyS0,115200 root=/dev/mtdblock3 rootfstype=jffs
2 rw
before init RAC 0x02a00000      0x00000000
after init RAC 0x02a0000f       0x0fff0000
Primary instruction cache 32kB, physically tagged, 2-way, linesize 16 bytes.
Primary data cache 32kB, 2-way, linesize 16 bytes.
Synthesized TLB refill handler (20 instructions).
Synthesized TLB load handler fastpath (32 instructions).
Synthesized TLB store handler fastpath (32 instructions).
Synthesized TLB modify handler fastpath (31 instructions).
timer irq 67 end 57
PID hash table entries: 2048 (order: 11, 8192 bytes)
Found MIPS counter frequency: 149 Mhz
Using 148.501 MHz high precision timer.
Console: colour dummy device 80x25
################## brcm_serial_console_init, sercon=80383120
Dentry cache hash table entries: 32768 (order: 5, 131072 bytes)
Inode-cache hash table entries: 16384 (order: 4, 65536 bytes)
Memory: 145024k/262144k available (3196k kernel code, 116948k reserved, 603k dat
a, 148k init, 0k highmem)
Mount-cache hash table entries: 512
Checking for 'wait' instruction...  available.
NET: Registered protocol family 16
registering PCI controller with io_map_base unset
registering PCI controller with io_map_base unset
SCSI subsystem initialized
usbcore: registered new driver usbfs
usbcore: registered new driver hub
SATA: Primary Bus Master Status Register offset = b0520000 + 00000300 = b0520300

SATA: before init Primary Bus Master Status reg = 0x00000000.
SATA: after init Primary Bus Master Status reg = 0x00000020.
NET: Registered protocol family 2
IP route cache hash table entries: 2048 (order: 1, 8192 bytes)
TCP established hash table entries: 8192 (order: 3, 32768 bytes)
TCP bind hash table entries: 4096 (order: 2, 16384 bytes)
TCP: Hash tables configured (established 8192 bind 4096)
TCP reno registered
JFFS2 version 2.2. (NAND) (SUMMARY)  (C) 2001-2006 Red Hat, Inc.
Initializing Cryptographic API
io scheduler noop registered
io scheduler anticipatory registered
io scheduler deadline registered
io scheduler cfq registered (default)
Broadcom serial driver version 1.00 (2000-11-09) with SERIAL_PCI enabled
Broadcom BCM7401 P31 Ethernet Network Device v2.0 Mar  1 2010 17:14:41
SUNDRY revision = 74010021, have IP Hdr Opt=1
Config Internal PHY Through MDIO: 100 MB Full-Duplex (auto-neg)
ata1: SATA max UDMA/133 cmd 0xB0510000 ctl 0xB0510020 bmdma 0xB0510030 irq 42
ata2: SATA max UDMA/133 cmd 0xB0510100 ctl 0xB0510120 bmdma 0xB0510130 irq 42
scsi0 : sata_svw
ata1: SATA link up 1.5 Gbps (SStatus 113 SControl F0000)
ATA: abnormal status 0xD0 on port 0xb051001c
ata1.00: ATA-6, max UDMA/133, 1953525168 sectors: LBA48 NCQ (depth 0/1)
ata1.00: ata1: dev 0 multi count 0
Data bus error, epc == 801ec2dc, ra == 801ea8d4
Oops[#1]:
Cpu 0
$ 0   : 00000000 10008000 000000df 812f9fbc
$ 4   : 804299cc 812f9e00 00000200 00000000
$ 8   : 00000100 00000001 00000000 81390000
$12   : 80428000 00000018 000f423f 0000000a
$16   : b0510000 80429850 804297ec 803e0000
$20   : 028f5c26 00000000 00000003 000f0000
$24   : 0000000d 00000000
$28   : 80374000 80375d30 8042987c 801ea8d4
Hi    : 00000000
Lo    : 000014d4
epc   : 801ec2dc ata_mmio_data_xfer+0x30/0xd4     Not tainted
ra    : 801ea8d4 ata_pio_sector+0x94/0xf4
Status: 10008002    KERNEL EXL
Cause : 0080801c
PrId  : 00020000
Modules linked in:
Process swapper (pid: 0, threadinfo=80374000, task=80376180)
Stack : 00000000 028f5c26 8042829c 801ef938 00000000 00000080 804297ec 801ea8d4
        00000050 8042829c 804297ec 803e0000 028f5c26 00000058 8042829c 801efd5c
        00000010 8008558c 804219b0 00000072 803e0000 803e0000 80421898 10008400
        00000000 80026e2c 803e8520 803def60 8042829c 812f8d00 00800000 000000ac
        812f8d00 00000001 00010001 000f0000 10008001 801f06b4 00000000 80085b04
        ...
Call Trace:
[<801ec2dc>] ata_mmio_data_xfer+0x30/0xd4
[<801ea8d4>] ata_pio_sector+0x94/0xf4
[<801efd5c>] ata_hsm_move+0x120/0x958
[<801f06b4>] ata_host_intr+0x120/0x168
[<80201a1c>] k2_sata_interrupt+0x168/0x260
[<800580d8>] handle_IRQ_event+0x84/0xf4
[<80058214>] __do_IRQ+0xcc/0x158
[<80005b44>] do_IRQ+0x1c/0x34
[<800032f0>] brcm_mips_int2_dispatch+0x188/0x228
[<80003efc>] ret_from_irq+0x0/0x10


Code: 00001021  00a01821  24420001 <960a0000> 0048482b  a46a0000  1520fffb  2463
0002  30c20001
Kernel panic - not syncing: Fatal exception in interrupt
 <0>Rebooting in 180 seconds..