mg_cfg in /usr/keys

# box type
B: { 06 }

HI,

I have the same problem with all mgcam. Momently I have a dreambox 8000 with card, and I have a 500HD C/T connected to dm8000 via local network. on both device the firmware: 3.3.2. The dm8000 has installed mgcam 1.30 and newcs 1.66. Everything is ok , the dm 500 can receive the card data from dm8000.

THE PROBLEM: now I installed the newest 4.03 to the dm500 and installed mgcam 1.3. I see the dm500 get the card details from dm8000 too BUT no any picture shows in dm500. Thats why I think something wrong with this firmware or mgcam in the newest firmware..

Any help pls:)
Thnx
Zsolt

1. check your mg_cfg as Joey said
2. try latest mgcamd version MGcamd 1.38

many thnx for it, It was the problem box type was automatic.. Now all is OK, thnx for that

Hey guys,

I have the same problem. I have two DMs. One DM800HD SE and one DM800HD SE v2.
The old one with 3.xx the new one with Newnigma2 v4.0.4.

On the old one the Mgcamd 1.38 works - on the new one NOT.

Already tried to change the box type in the mg_cfg to all values (from 00 to 05). Nothing seems to work.

Any solution? Don't want to wast the new box.

Thanks a lot.

Chris

Aiyo. Could swear that I tried 06 before I went through 00 to 05.
However now it works. Thank you so much.

i have this problem with dm7020hdv2, i cannot get mgcamd higher than 1.30 to work in my new v2 box?
1.31, 1.35 and 1.38 is installed together with 1.3o but this is the only one working? any ideas?