DVI problem

    • DVI problem

      Sorry about English!

      I recently installed the new image 4.0.10 and discovered something strange, when watching tv the DVI connection was suddenly lost. Problem is with any output resolution.
      Is this a bug of image?


      Thanks!

      Dieser Beitrag wurde bereits 2 mal editiert, zuletzt von saf ()

    • Hmm.. After updating from 4.0.9 to 4.0.10, I see the same problem as you.
      The DVI/HDMI signal is sometime lost, and my LG TV (32LA667V-ZB) is making strange things, on the HDMI input. I have other devices connected to my TV (a Raspberry PI with CEC), at that unit is going craisy, when I connect my DB800 to my TV, and the picture is blinking/flasking.
      I think, that there is some error in the DVI/HDMI signaling, when I use the image 4.0.10 :(

      Offen I can watch my DB800 for hours, and the suddenly the picture on my TV, starts to blink/flash. And sometimes the video signal it's gone for 10 sec.

      I have tryed any combinations, of my 3 HDMI input on my TV, but same problem...
      I have also updated the LG, with the newsed Firmware, but no...
      I have tryed to take the DB800 output, at put it into a HDMI switch, but the TV is also sometimed blinking/flasking via that.

      Image 4.0.9 works perfect for me, but not 4.0.10. I have flashed Newnigma back and forward many times, and the error is only on the 4.0.10

      Best regards.