Ich habe ein Iomega mdhd500-s Case mit einer ST3750640AS 3,5", die leider nicht mit dem Release, Unstable und mit dem aktuellen DMM-Image erkannt wird :o(
Welche Platten werden bei Euch erkannt und nicht erkannt?
Frohes Osterfest
Alles anzeigen
Welche Platten werden bei Euch erkannt und nicht erkannt?
Frohes Osterfest
Quellcode
- --> brcm_pcibios_fixup_SATA
- PCI DEV in slot 0, ID=14e4:8602
- SATA: Primary Bus Master Status Register offset = b0520000 + 00000300 = b0520300
- SATA: before init Primary Bus Master Status reg = 0x00000000.
- SATA: after init Primary Bus Master Status reg = 0x00000020.
- SATA: Secondary Bus Master Status Register offset = b0520000 + 00000300 = b0520300
- SATA: before init Secondary Bus Master Status reg = 0x00000000.
- SATA: after init Secondary Bus Master Status reg = 0x00000060.
- PCI: Failed to allocate mem resource #6:20000@b0520000 for 0000:01:00.0
- TC classifier action (bugs to netdev@vger.kernel.org cc hadi@cyberus.ca)
- ...
- Broadcom BCM7400B0 SATA2 IDE: IDE controller at PCI slot 0000:01:00.0
- Broadcom BCM7400B0 SATA2 IDE: chipset revision 0
- Broadcom BCM7400B0 SATA2 IDE: 100% native mode on irq 42
- ide0: BM-DMA at 0x0300-0x0307, BIOS settings: hda:DMA, hdb:pio
- ide1: BM-DMA at 0x0308-0x030f, BIOS settings: hdc:DMA, hdd:DMA
Dieser Beitrag wurde bereits 1 mal editiert, zuletzt von -=AS=- ()