Tune failed problem

blue-yu · 27. September 2010, 10:53

Hello,

Almost every time i move dish to change satellite i get message "Tune failed". The problem is always present when motor have to travel a lot, but not present when i change to near satellite. Solution is to wait motor to stop, and than change to other channel and return to the wanted one. Tested on 3.0.1, and also on 3.0.2.

Is there a solution for this problem?

Igor1312 · 27. September 2010, 17:06

Hi,

maybe the enigma2-plugin-systemplugins-satelliteequipmentcontrol works for you.
There are some settings dealing with delay after motor comands.
Try it, I have no motor, nor multi satellites.

Bye,
Igor

johntee50 · 27. September 2010, 17:13

It appears there are some files missing from the images. Read the move motor post a bit further down. I've been trying to find out what the missing files are, but without success.

Regards, JT.

Kobazz · 27. September 2010, 17:31

I also still have this issue with 3.0.2.

Any idea which motor setting we should set a bigger delay for in satelliteequipmentcontrol to prevent the "tuner failed" error?

deas · 28. September 2010, 22:10

I got the same issue on my dm800, but i dont have a motor i only use 2 lnd to diseq and i get "tuning failed" like 99,9% of the time when i zap. it all started when i upgraded to 3.0.2 so i guess "tuning zapping performance for dm800" got something to do with it...

anyone got any idea?!

Kobazz · 17. Dezember 2010, 18:51

This issue is solved for me with 3.1.2

good work

cheers

Tune failed problem

Tune failed problem

RE: Tune failed problem

Teilen