SmartReader Plus drivers?

realjobe · 10. Oktober 2012, 18:59

Hi.
Have anyone got succesfully installed SmartReader Plus to read smartCards..
How to install, where to get kernel module drivers for NewNigma v3.3.2

sparksofinsanity · 10. Oktober 2012, 19:02

All USB/Serial Drivers are preinstalled in all our Images.

realjobe · 10. Oktober 2012, 19:23

so. was it wrong to install
feed.newnigma2.to/stable/dm702…2.6.18-r50.2_dm7020hd.ipk
and
feed.newnigma2.to/stable/dm702…2.6.18-r50.2_dm7020hd.ipk

Devicemanager seems to show the reader but it disappears quite often.. everytime i insert the card actually.

sparksofinsanity · 10. Oktober 2012, 19:42

Again, the two packages are already preinstalled in all our Images.

realjobe · 10. Oktober 2012, 20:02

ok, So i did not break anything by installing these again?
Installer said "1 pack installed succesfully" for both of those ipk files...

Why does you think the device manager looses the Reader when I insert the card?
How do I use this is Cccam config? /dev/?

LoUiS · 10. Oktober 2012, 21:11

Original von realjobe
ok, So i did not break anything by installing these again?
Installer said "1 pack installed succesfully" for both of those ipk files...

Why does you think the device manager looses the Reader when I insert the card?
How do I use this is Cccam config? /dev/?

No, you didn't break anything, you just installed the preinstalled drivers once again.

So there was no need to do so.

You are able to configure your smartreader plus in the Newnigma2 devicemanager.
After you have configured the device, you can use the different slots as /dev/ttyUSB0 - /dev/ttyUSB1 and further on for your CCcam.cfg.

realjobe · 11. Oktober 2012, 06:38

1st, Thank you for helping me.
I have not been able to do enything but the see the SmartReader in the DeviceManager. No button shows any menu etc where to adjust it. Device is ttyUSB0 if I can recall correctly what was on the screen

E2 Boots if I press ok on the smartCard device on the devicemanager. No crash log etc showd. SmartCard reader is set to DreamBox kernel..

EverythingZen · 11. Oktober 2012, 13:30

Smargo has to been set to kernel normal.

realjobe · 11. Oktober 2012, 16:31

ok.. helped, Now I could read old Canal+ cards with oscam/cccam but my new card just won't open with ccam. osam reads it but can't use it...

EverythingZen · 11. Oktober 2012, 16:57

it's probably a good idea to ask your question in the emu section cccam or others (oscam). i can't help you with canal+ but this surely is a config or oscam version problem.

Teilen