NewNigma unstable 01/2013 and Smargo CardReader?

    • NewNigma unstable 01/2013 and Smargo CardReader?

      Hi there.
      Using "newnigma2-unstable-dm7020hd-07_01_2013" and I have some trouble using smargo cardreader with Cccam 2.3.0. Smargo has kernel Dreambox, not normal.

      The reader works great with Debian Oscam 1.2 b800x as is. Freq =5Mhz there.
      lsusb in dreambox does not show the device.

      Do I need to install USBSerial drivers? Will /dev/ttyUSB0 work?

    • ok.. And the device pointing is that /dev/ttyUSB0?
      Do I need to boot the DreamBox Up with the readerHW attached or can it be pluged in afterwards?

      So the Image do have the USBSerial drivers already installed and running?

    • Strange.

      I pluged the reader in, but lsusb does not show any usb device attached. LED blinked on the reader so hw is working.. Isn't lsusb suppose to show the device's name etc..Now i have only BUS 1-4 with nothing but Device & id.

      dmesg shows:

      Quellcode

      1. [39277.970000] usb 4-1: new full-speed USB device number 2 using ohci-brcm
      2. [39278.173000] usbcore: registered new interface driver usbserial
      3. [39278.174000] USB Serial support registered for generic
      4. [39278.175000] usbcore: registered new interface driver usbserial_generic
      5. [39278.176000] usbserial: USB Serial Driver core
      6. [39278.206000] USB Serial support registered for FTDI USB Serial Device
      7. [39278.207000] ftdi_sio 4-1:1.0: FTDI USB Serial Device converter detected
      8. [39278.208000] usb 4-1: Detected FT232BM
      9. [39278.209000] usb 4-1: Number of endpoints 2
      10. [39278.209000] usb 4-1: Endpoint 1 MaxPacketSize 64
      11. [39278.210000] usb 4-1: Endpoint 2 MaxPacketSize 64
      12. [39278.210000] usb 4-1: Setting MaxPacketSize 64
      13. [39278.213000] ftdi_sio ttyUSB0: Unable to read latency timer: -32
      14. [39278.214000] usb 4-1: FTDI USB Serial Device converter now attached to ttyUSB0
      15. [39278.215000] usbcore: registered new interface driver ftdi_sio
      16. [39278.216000] ftdi_sio: v1.6.0:USB FTDI Serial Converters Driver
      Alles anzeigen


      So, is the Device drivers loaded now?
      How do I use this in Cccam.cfg? /dev/ttyUSB0? nothing seems to work.. card mhz needs to be 5Mhz.

      Dieser Beitrag wurde bereits 3 mal editiert, zuletzt von realjobe ()

    • nope.
      although dmesg | grep usb shows "usb 4-1: FTDI USB Serial Device converter now attached to ttyUSB0"

      SERIAL READER : /dev/ttyUSB0 smartreader+ does not work..
      Reader is at normal kernel.

      edit.. Worked with another card, but not with my correct card.. must be the mhz..

      Dieser Beitrag wurde bereits 1 mal editiert, zuletzt von realjobe ()