Hi great boys!
Since two last days, I am trying to put in operation the Newnigma2 v2.8.1 on my DM600
I have seen that you have closed the FORUM section of DM600, for this reason I write here.
FTA channels work correctly,
the problem is that the network does not work correctly.
It is really strange because:
Network Adapter: TEST OK
DHCP: TEST OK
IP Address: TEST OK
Nameserver: TEST OK
Local Network: ---> KO <---
For this reason, I cannot use the CCCAM 2.1.3 that is mounted in this firmware...
Can you help me?
What can be the reason of the block of the internet network?
I have DM600 pvr-S (that I used in the past with other images and CCCams, without problems)
I hope to receive Your answer
thanks!
aus "DM800se"
Since two last days, I am trying to put in operation the Newnigma2 v2.8.1 on my DM600
I have seen that you have closed the FORUM section of DM600, for this reason I write here.
FTA channels work correctly,
the problem is that the network does not work correctly.
It is really strange because:
Network Adapter: TEST OK
DHCP: TEST OK
IP Address: TEST OK
Nameserver: TEST OK
Local Network: ---> KO <---
For this reason, I cannot use the CCCAM 2.1.3 that is mounted in this firmware...
Can you help me?
What can be the reason of the block of the internet network?
I have DM600 pvr-S (that I used in the past with other images and CCCams, without problems)
I hope to receive Your answer
thanks!
aus "DM800se"
Dieser Beitrag wurde bereits 1 mal editiert, zuletzt von Joey () aus folgendem Grund: Beitrag verschoben