=~=~=~=~=~=~=~=~=~=~=~= PuTTY log 2016.01.09 18:14:54 =~=~=~=~=~=~=~=~=~=~=~=

Dreambox DM7 080


M0

M1

SHMOO
0
00000000
1
00000000
C
do_boot

.
go
..
[ 0.000000] Initializing cgroup subsys cpuset
[ 0.000000] Initializing cgroup subsys cpu
[ 0.000000] Linux version 3.4-3.5-dm7080 (newnigma2@nn2build.newnigma2.to) (gcc version 4.8.1 (GCC) ) #7 SMP Mon Nov 9 09:09:09 CET 2015
[ 0.000000] Fetching vars from bootloader... none present, using defaults.
[ 0.000000] Options: moca=0 sata=1 pcie=1 usb=1
[ 0.000000] Using 1024 MB + 1024 MB RAM (from CFE)
[ 0.000000] bootconsole [early0] enabled

[ 0.091000] RPC: Registered tcp NFSv4.1 backchannel transport module.
[ 0.092000] PCI: Enabling device 0000:00:00.0 (0000 -> 0002)
[ 0.094000] highmem bounce pool size: 64 pages
[ 0.095000] NFS: Registering the id_resolver key type
[ 0.096000] SGI XFS with security attributes, large block/inode numbers, no debug enabled
[ 0.098000] msgmni has been set to 979
[ 0.099000] Block layer SCSI generic (bsg) driver version 0.4 loaded (major 254)
[ 0.100000] io scheduler noop registered
[ 0.100000] io scheduler cfq registered (default)
[ 0.101000] Serial: 8250/16550 driver, 4 ports, IRQ sharing disabled
[ 0.102000] serial8250.0: ttyS0 at MMIO 0x10406b00 (irq = 67) is a 16550A
[ 0.103000] console [ttyS0] enabled, bootconsole disabled
[ 0.103000] console [ttyS0] enabled, bootconsole disabled
[ 0.105000] loop: module loaded

olver key type
[ 0.889000] PM: CP0 COUNT/COMPARE frequency does not depend on divisor
[ 0.890000] EBI CS0: setting up SPI flash (primary)
[ 0.891000] spi_brcmstb spi_brcmstb.0: master is unqueued, this is deprecated
[ 0.892000] spi_brcmstb spi_brcmstb.0: 1-lane output, 3-byte address
[ 0.892000] m25p80 spi0.0: mx25l12805d (16384 Kbytes)
[ 0.894000] Creating 3 MTD partitions on "spi0.0":
[ 0.894000] 0x000000000000-0x000001000000 : "entire_device"
[ 0.895000] 0x000000000000-0x000000100000 : "bootloader"
[ 0.896000] 0x000000100000-0x000001000000 : "recovery"
[ 0.898000] ALSA device list:
[ 0.898000] No soundcards found.
[ 0.899000] Waiting for root device /dev/mmcblk0p1...
[ 0.982000] mmc0: new high speed MMC card at address 0001
[ 0.983000] mmcblk0: mmc0:0001 SEM04G 3.68 GiB
[ 0.984000] mmcblk0boot0: mmc0:0001 SEM04G partition 1 2.00 MiB
[ 0.985000] mmcblk0boot1: mmc0:0001 SEM04G partition 2 2.00 MiB
[ 0.991000] mmcblk0: p1 p2
[ 0.992000] ata2: SATA link up 6.0 Gbps (SStatus 133 SControl 300)
[ 0.993000] mmcblk0boot1: unknown partition table
[ 0.994000] mmcblk0boot0: unknown partition table
[ 0.998000] ata2.00: ATA-8: ST1000LM024 HN-M101MBB, 2BA30001, max UDMA/133
[ 0.999000] ata2.00: 1953525168 sectors, multi 0: LBA48 NCQ (depth 0/32)
[ 1.009000] ata2.00: configured for UDMA/133
[ 1.009000] scsi 1:0:0:0: Direct-Access ATA ST1000LM024 HN-M 2BA3 PQ: 0 ANSI: 5
[ 1.011000] sd 1:0:0:0: [sda] 1953525168 512-byte logical blocks: (1.00 TB/931 GiB)
[ 1.012000] sd 1:0:0:0: [sda] 4096-byte physical blocks
[ 1.012000] sd 1:0:0:0: [sda] Write Protect is off
[ 1.013000] sd 1:0:0:0: [sda] Write cache: enabled, read cache: enabled, doesn't support DPO or FUA
[ 1.067000] sda: sda1 sda2
[ 1.068000] sd 1:0:0:0: [sda] Attached SCSI disk
[ 1.162000] usb 9-1: new full-speed USB device number 2 using xhci_hcd
[ 9.390000] mmcblk0: error -145 transferring data, sector 147458, nr 2, cmd response 0x900, card status 0x80b00
[ 9.391000] mmcblk0: retrying using single block read
[ 17.780000] mmcblk0: error -145 transferring data, sector 147458, nr 2, cmd response 0x900, card status 0x0
[ 17.782000] end_request: I/O error, dev mmcblk0, sector 147458
[ 26.171000] mmcblk0: error -145 transferring data, sector 147459, nr 1, cmd response 0x900, card status 0x0
[ 26.172000] end_request: I/O error, dev mmcblk0, sector 147459
[ 26.173000] EXT4-fs (mmcblk0p1): unable to read superblock
[ 26.181000] List of all partitions:
[ 26.181000] 1f00 16384 mtdblock0 (driver?)
[ 26.182000] 1f01 1024 mtdblock1 (driver?)
[ 26.182000] 1f02 15360 mtdblock2 (driver?)
[ 26.183000] b300 3866624 mmcblk0 driver: mmcblk
[ 26.183000] b301 974848 mmcblk0p1 2772e6f1-cc92-4ac0-9075-66d1c6451812
[ 26.184000] b302 2817024 mmcblk0p2 d82007c2-aaf8-4907-a3fd-c479d2c85d8c
[ 26.185000] b310 2048 mmcblk0boot1 (driver?)
[ 26.186000] b308 2048 mmcblk0boot0 (driver?)
[ 26.186000] 0800 976762584 sda driver: sd
[ 26.187000] 0801 975712984 sda1 70b45a95-7142-4b55-809c-1ca149874191
[ 26.188000] 0802 1047600 sda2 71c94ea7-c491-402f-b6d2-1f6b9d924b4b
[ 26.189000] No filesystem could mount root, tried: ext4
[ 26.189000] Kernel panic - not syncing: VFS: Unable to mount root fs on unknown-block(179,1)
[ 26.190000] Rebooting in 180 seconds..
[ 26.190000] ------------[ cut here ]------------
[ 26.190000] WARNING: at smp.c:464 smp_call_function_many+0x118/0x3a0()
[ 26.190000] Modules linked in:
[ 26.190000] Call Trace:
[ 26.190000] [<805bba70>] dump_stack+0x8/0x34
[ 26.190000] [<80023abc>] warn_slowpath_common+0x78/0xa4
[ 26.190000] [<80023b70>] warn_slowpath_null+0x18/0x24
[ 26.190000] [<80076790>] smp_call_function_many+0x118/0x3a0
[ 26.190000] [<80076a44>] smp_call_function+0x2c/0x3c
[ 26.190000] [<802dce1c>] brcm_machine_restart+0x10/0x44
[ 26.190000] [<805bbc30>] panic+0x194/0x20c
[ 26.190000] [<806fa06c>] mount_block_root+0x258/0x2a8
[ 26.190000] [<806fa1ec>] mount_root+0x130/0x15c
[ 26.190000] [<806fa39c>] prepare_namespace+0x184/0x224
[ 26.190000] [<806f9c64>] kernel_init+0x258/0x260
[ 26.190000] [<800065cc>] kernel_thread_helper+0x10/0x18
[ 26.190000]
[ 26.190000] ---[ end trace 6954a16c54db4583 ]---

Dreambox DM7 080


M0

M1

SHMOO
0
00000000
1
00000000
C
do_boot

.
go

[ 26.193000] Rebooting in 180 seconds..