Hallo Team,
um auf die Serielle Konsole der dm900 zuzugreifen nutze ich unter OSX das Kommando
Seit kurzem stelle ich fest, wenn ich mir die Ausgaben auf der Konsole
anschauen will, gehen die Ausgeben nur bis zur Zeile
Alles anzeigen
Weiß jemand, was ich falsch mache?
Gruß
um auf die Serielle Konsole der dm900 zuzugreifen nutze ich unter OSX das Kommando
Seit kurzem stelle ich fest, wenn ich mir die Ausgaben auf der Konsole
anschauen will, gehen die Ausgeben nur bis zur Zeile
Brainfuck-Quellcode
- CS1: NAND: unrecognized ID: 0xffff 0xffffffff
- RTS0: 0x1101004, 256 clients, ok
- RTS1: 0x1181004, 256 clients, ok
- BOX MODE: 5
- card if inited
- set pwm to 0/255
- disp id 5420
- load image
- AVS: park check
- AVS: temperature monitoring enabled
- AVS: STB: V=0.901V, T=+70.114C, PV=0.840V, MV=0.903V, FW=30333278 [0.3.2.x]
- USB otp=00000040
- USB @ 0xf0470200: IPP is active low, IOC is negative polarity
- init fp
- found card in unknown state
- ca valid!
- set pwm to 200/255
- Normal bootup
- Loader:zimg Filesys:raw Dev:emmcflash0.kernel File: Options:(null)
- Reading 4249512 bytes from zImage...........
- Starting program at 0x8000 (DTB @ 0x7728000)
- 32 bit boot...
- Uncompressing Linux... done, booting the kernel.
Gruß